The Best Crossword Puzzle Maker Online
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crossword Word Search Worksheet
Rate This Puzzle:
Log in or sign up to rate this puzzle.

Codes, Practices, and Standards Level 1 - Lessons 9,10,11

Across
Conductor tension and stress on a receptacle usually results from ___________ the device box
Switch loops for 3 and 4-way switch installation are also referred to as these
This is required to connect the grounding terminal of a grounding type receptacle to a grounded box
Manufacturer's association that provides a forum for the standardization of electrical equipment
A point on a wiring system at which current is taken to supply utilization equipment
A contact device installed at the outlet for the connection of an attachment plug
Wiring devices which utilize curved blades which insert directly into their mating receptacles and connectors and then require a turn to engage
Installations underground or in concrete slabs or masonry in direct contact with the earth; in locations subject to saturation with water or other liquids
A wiring device which is a portable receptacle, provides a means of attachment to a flexible cord, and which is not intended for permanent mounting
Down
This type of receptacle is intended to reduce the effects of electrical noise (electromagnetic interference)
Worldwide standards organization
All switching is required to be don only in this conductor
In a receptacle, these serve as the contacts between the device and the conductors. They are commonly made of brass or other conductive alloy
An outlet where one or more receptacles are installed
Switches or circuit breakers shall not disconnect this conductor of a circuit
A device that, by insertion in a receptacle, establishes a connection between the conductors of the attached flexible cord and the conductors connected permanently to the receptacle
Receptacles are required to be installed in boxes or __________ which are designed for that purpose
Locking plug blade and/or connector contact configurations which do not conform to NEMA standards
These types of receptacles must have a terminal identified by a green-colored finish, the words "green" or "ground" or the letters "G" or "GR", or a grounding symbol.
Locations protected from weather and not subject to saturation with water but subject to moderate degrees of moisture
A location not normally subject to dampness or wetness
You will see these switches in most electrical installations